{"title":"Commercial Peelers","description":"\u003cp\u003eCommercial peelers strip potatoes, onions and garlic in batches, replacing hours of hand work with cycles measured in a minute or two. Abrasive drum models handle potato loads by the batch, while dedicated garlic and onion units spare staff the tedious, eye-watering part of prep. Restaurants, institutional kitchens and delis producing fries, mash, soups and sauces get consistent yield with less trim loss and fewer knife hours. Batch size and horsepower vary by model, so match the machine to your daily volume, then pair it with \u003ca href=\"\/collections\/vegetable-prep-machines\"\u003evegetable prep machines\u003c\/a\u003e and \u003ca href=\"\/collections\/food-processors\"\u003ecommercial food processors\u003c\/a\u003e for the cutting that follows.\u003c\/p\u003e","products":[{"product_id":"hobart-6430-commercial-potato-peeler-30-lb-capacity-3-4-hp","title":"Hobart 6430 Commercial Potato Peeler — 30 lb Capacity, 3\/4 HP","description":"\u003cp\u003eThirty pounds of potatoes peeled in a single load, in a matter of minutes, with water doing the rinsing and a drain carrying the peelings away. The Hobart 6430 is the mid-size floor peeler in Hobart's line, built for restaurants, cafeterias and banquet kitchens that run fresh potatoes, carrots and root vegetables every day and want that work off the prep sink.\u003c\/p\u003e\u003cp\u003eA 3\/4 HP motor turns a 20-1\/2-inch abrasive disc through a multigrip poly V-belt on a stainless steel shaft. The shaft bearings are grease packed and sealed against water. Silicon carbide is permanently bonded to the lightweight fiberglass-reinforced disc, and two angled wipers push waste to the outlet so the chamber keeps peeling cleanly load after load. The 5-minute timer sets in increments from 30 seconds, so every load comes out to the same finish. The gray molded hopper cover locks in place with a viewing opening, so you can check progress without stopping the machine, and the peeler will not run without it.\u003c\/p\u003e\u003cp\u003eThe body is heliarc-welded, glass-beaded stainless steel with a removable NSF Lexan liner, a cam-lock aluminum discharge door and a rubber-trimmed base. The liner, disc and hopper cover all come out for cleaning, and a manual-reset thermal overload protects the motor. The peeler sets onto Hobart's optional cabinet base or peel trap in any of four positions at 90 degrees, so the discharge chute can face whichever way your prep area needs.\u003c\/p\u003e\u003cp\u003ePlan the install before it arrives. The 6430 needs a cold water line to its 1\/2-inch female pipe-thread fill connection and a floor drain or trap for its 2-3\/8-inch I.D. drain hose (the optional peel trap drains through a 2-inch male pipe thread). It has no cord; it is permanently wired through a 7\/8-inch conduit hole for 115\/60\/1, 200-230\/60\/1 or 240\/50\/1 service. It stands 35-13\/16 inches tall, 21 inches across and 27-1\/4 inches front to back, ships at 157 pounds, is UL listed and NSF approved, and carries Hobart's one-year parts and labor warranty.\u003c\/p\u003e","brand":"Hobart","offers":[{"title":"115\/60\/1","offer_id":50527912099998,"sku":"HOB-6430-1","price":21130.0,"currency_code":"CAD","in_stock":true},{"title":"115\/60\/1 (Canada Config)","offer_id":68068243865758,"sku":"HOB-6430-13","price":21130.0,"currency_code":"CAD","in_stock":true},{"title":"200-230\/60\/1","offer_id":68056334205086,"sku":"HOB-6430-3","price":21960.0,"currency_code":"CAD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0787\/0460\/7390\/files\/Peeler_206430_20qr_20.png?v=1790314522"},{"product_id":"hobart-6115-commercial-potato-peeler-15-lb-capacity-1-3-hp","title":"Hobart 6115 Commercial Potato Peeler — 15 lb Capacity, 1\/3 HP","description":"\u003cp\u003eFifteen pounds of potatoes in, peeled potatoes out, and nobody at the prep sink with a peeler in hand. The Hobart 6115 is the compact member of Hobart's peeler line, sized for restaurants, cafeterias and cafes that go through a few sacks of potatoes, carrots or beets a day and want that time back from their prep cooks.\u003c\/p\u003e\u003cp\u003eA 14-3\/4-inch abrasive disc spins the load against the hopper wall, and the silicon carbide grit bonded to its fiberglass-reinforced face takes the skin off while water flushes peelings down the drain. A 1\/3 HP motor drives the disc through dual V-belts on a stainless steel shaft, and the 5-minute timer sets in increments from 30 seconds up, with 15-second marks on the dial, so every load gets the same peel and you stop losing product to over-peeling. The rear water inlet sprays against the curved hopper cover, rinsing the inside of the chamber as it runs. When the load is done, open the cam-lock discharge door and the product comes out by itself.\u003c\/p\u003e\u003cp\u003eThe housing is heliarc-welded satin stainless steel, the hopper wears a removable NSF Lexan liner, and both the liner and the abrasive disc lift out for cleaning. The brushed aluminum hopper cover locks in, and the peeler will not run without it in place. A manual-reset thermal overload protects the motor if a load bogs it down.\u003c\/p\u003e\u003cp\u003ePlan for water and a drain. The 6115 needs a cold water supply: the 5-foot fill hose slips over a standard faucet, or you can plumb a permanent line to the 1\/2-inch female pipe-thread fill connection. It drains through a 2-inch male pipe-thread connection into a floor drain or sink. Order it for 115V, 60 Hz (7.2 amps, NEMA 5-15P on a 5-1\/2-foot cord), 230V, 60 Hz (3.6 amps, NEMA 6-15P) or 230V, 50 Hz export service. It measures 16-1\/2 inches across the hopper cover, 21 inches front to back and 29-27\/32 inches tall to the fill tube, and weighs 60 pounds. It is UL listed and NSF approved, and Hobart covers it for one year on parts and labor. A portable stand, cabinet base with peel trap and peel trap basket are available separately.\u003c\/p\u003e","brand":"Hobart","offers":[{"title":"Default Title","offer_id":50527937036446,"sku":"HOB-6115-10","price":12556.0,"currency_code":"CAD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0787\/0460\/7390\/files\/Peeler_206115_20qr_20.png?v=1790263268"},{"product_id":"hobart-6460-commercial-potato-peeler-60-lb-capacity-1-hp","title":"Hobart 6460 Commercial Potato Peeler — 60 lb Capacity, 1 HP","description":"\u003cp\u003eUp to 60 pounds of potatoes in a single load: the Hobart 6460 is the largest peeler in Hobart's line, a 1 HP floor machine for the kitchens that measure potatoes by the sack. Hospital and school production kitchens, commissaries, banquet operations and high-volume restaurants use it to turn a morning of hand peeling into a few quick cycles.\u003c\/p\u003e\u003cp\u003eThe 1 HP motor drives a 20-1\/2-inch abrasive disc through a multigrip poly V-belt on a stainless steel shaft, with sealed, grease-packed ball bearings that keep water out. Silicon carbide is permanently bonded to the lightweight fiberglass-reinforced disc, and two angled wipers sweep peelings to the outlet so a full chamber keeps peeling evenly. The gray molded hopper cover locks down with a viewing opening, so the operator can watch the peel and open the door at the right moment, and the peeler will not run with the cover off. Single-phase units carry the 5-minute timer, and three-phase units run from the tumbler switch.\u003c\/p\u003e\u003cp\u003eThe cylinder is heliarc-welded, glass-beaded stainless steel with a removable NSF Lexan liner, a cam-lock cast aluminum discharge door and a rubber-trimmed base. The liner, disc and cover all come out for cleaning, and a manual-reset thermal overload protects the motor. Mount it on Hobart's optional cabinet base or peel trap, turned to any of four positions, so the chute discharges where your prep line needs it.\u003c\/p\u003e\u003cp\u003eThis is a plumbed, hardwired machine. It needs a cold water line to the 1\/2-inch female pipe-thread fill connection and a floor drain or trap for its 2-3\/8-inch I.D. drain hose (the optional peel trap drains through a 2-inch male pipe thread). It is permanently wired through a 7\/8-inch conduit hole and orderable for 115\/60\/1, 200-230\/60\/1 or 200-230\/60\/3 service, all UL listed, or for 220-240\/50\/1 and 380-415\/50\/3 export service. It stands 38-3\/8 inches tall, 21 inches across and 27-1\/4 inches front to back, ships at 164 pounds, is NSF approved, and carries Hobart's one-year parts and labor warranty.\u003c\/p\u003e","brand":"Hobart","offers":[{"title":"Standard","offer_id":50527937462430,"sku":"HOB-6460-1","price":22075.0,"currency_code":"CAD","in_stock":true},{"title":"200-230V\/60\/1","offer_id":68056330076318,"sku":"HOB-6460-3","price":22747.0,"currency_code":"CAD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0787\/0460\/7390\/files\/i_c52f3eda-c45a-4174-8903-a0fda58fcb57.jpg?v=1791701048"}],"url":"https:\/\/directfoodequipment.com\/collections\/commercial-peelers.oembed","provider":"Direct Food Equipment","version":"1.0","type":"link"}